Just remember chains are no good at pushing. Make sure you've got a method to stop it in case it gets a gallop on once you've got it moving!
- Thread starter monkeymark
- Start date
There's what looks like a morse taper piece with it not sure what size but it's about the same width as the removable quick change piece in the 50 taper end.
Probably no good for me so hopefully friend can use it in the mill otherwise if anyone wants it then pm.
What is it?
Aka someone offered him more and he is just waiting to see if they view the carI am trying to aquire a Mercedes 190 Cosworth. After seeing the car on Saturday and agreeing the sellers asking price that I'd take it, he then said he isnt sure if he is selling it and will come back to me
JOEPRO
Member
- Messages
- 4,867
- Location
- UK
That or he is still trying to see if he can wring more £ out of it yes. Maybe trying to get others interested as its not advertised that I know of.
arther dailey
Member
- Messages
- 6,885
- Location
- England
if its not advertised perhaps he was nt intending selling and is cchecking out current actual maket value , although after agreeing a price is some what bad form .good luck with the purchase
JOEPRO
Member
- Messages
- 4,867
- Location
- UK
if its not advertised perhaps he was nt intending selling and is cchecking out current actual maket value , although after agreeing a price is some what bad form .good luck with the purchase
Well I just messaged to say my offer expires at midday tomorrow so at least now ill know by tomorrow. Aka I will move on at that point and forget about the car. If he is trying to get better £ he won't be doing it on my time!
Memmeddu
Member
- Messages
- 5,425
- Location
- Italia Sardegna
What do you suggest?
My idea was laying down some sheets because it's actually on ground right now.
Lift it up little bit to put 12mm at the most round bars (so it's not able to tilt), put a belt at the lowest of the column and slowly moving it using the lever hoist.
Almost on flat slightly uphill then once on concrete using a pry bar
Memmeddu
Member
- Messages
- 5,425
- Location
- Italia Sardegna
Not even our bigger machines at work use iso 50 at work.
They are all iso 40 except for the jib borer that uses Morse taper 5 with retaining wedges and a four lugs tool holder for the boring and milling attachments
I believe this boring heads is from an huge machine in the 15 up to 25ish HP size as ours are 12HP using iso 40
Would definitely work just need to seal with food safe resin/epoxy, only problem is pla tends to get very soft once you're close to 50°c so would be like trying to hold a thin paper cup about to rip if you put anything boiling in!
arther dailey
Member
- Messages
- 6,885
- Location
- England
shame , its an uncomfortable feeling , been there myself , done a deal on a mig welder offered for sale only to be told later a "relative" had bought it ! but we all have these sort of things fall through eh , onwards and upwards .
