- Thread starter God mode restorations
- Start date
Pete.
Member
- Messages
- 15,005
- Location
- Kent, UK
I made an adapter for holding Morse taper 4 arbors for machining them.
Bought a capstan sleeve which is MT4 inside and parallel outside.
I chucked it up in my lathe and checked to see if the parting tool would cut it - it did!
Parted off:
Now I can hold my morse taper arbors in the chuck and turn either end.
Bought a capstan sleeve which is MT4 inside and parallel outside.
I chucked it up in my lathe and checked to see if the parting tool would cut it - it did!
Parted off:
Now I can hold my morse taper arbors in the chuck and turn either end.
Hood
I am obsessed.
- Messages
- 17,917
- Location
- Carnoustie, Scotland
Eventually got the Polyurethane had messaged them asking when it would arrive but no reply and it is natural colour instead of the black it is supposed to be, won't be buying from them again.Be interesting to see how you get on with this, I've a few bits I wouldn't mind trying myself
I should really have just sent it back but I wanted to try it out to see how things went and it was quite successful although I think I will modify the mould a bit to make pouring easier.
Anyway here is what came out.
Very flexible and seems strong as can be seen in the pics below I could easily stretch the neck which is 8.5mm dia over the 16mm ball and the 16mm shaft so that I could assemble things. The surface is slightly sticky but whether that will change through time I don't know.
I have ordered some 85 shore from a different place, also with black pigment so I will see what that is like but overall it seems like it will work for me.
4000k, cheap 12v gu5.3 bulbs
Brad93
Member
- Messages
- 19,329
- Location
- Essex, United Kingdom
@Matchless may be a possibility
I seem to recall that 24 yrs ago my pal was using red LED lighting on simple time clocks . It might be worth a bit of researching for winter egg production .4000k, cheap 12v gu5.3 bulbs
