Brad93
Member
- Messages
- 17,577
- Location
- Essex, United Kingdom
Haven’t touched this for months except to strip down the tail stock.
I need to take the apron off to give it a good clean up as there is quite a bit of gunk and swarf inside.
However the two retaining nuts on the leadscrew are mega tight. Can’t remove with any tools I’ve got here so I’ve ordered a pair of Gedore Pin C-Spanner’s which should fit.
Can anyone help me identify what these harrison c spanner’s would of been used for?
In the listing they mentioned a collect chuck and collets but they were hidden or taken away when I questioned them about it.
Perhaps that’s what they would have fitted.
I also need to strip the screw cutting gearbox down as someone has used grease on that in the past. All moves freely but it’s gummy.
Anyone got any pointers on taking it apart?
I need to take the apron off to give it a good clean up as there is quite a bit of gunk and swarf inside.
However the two retaining nuts on the leadscrew are mega tight. Can’t remove with any tools I’ve got here so I’ve ordered a pair of Gedore Pin C-Spanner’s which should fit.
Can anyone help me identify what these harrison c spanner’s would of been used for?
In the listing they mentioned a collect chuck and collets but they were hidden or taken away when I questioned them about it.
Perhaps that’s what they would have fitted.
I also need to strip the screw cutting gearbox down as someone has used grease on that in the past. All moves freely but it’s gummy.
Anyone got any pointers on taking it apart?