Stuff you have made today

[RichardM]

Yes

 

[Mick Annick]

Ha ha I was waiting on someone saying that
It is fine, I have put some adhesive lined heat shrink on the cable where it exits the gland and had it bent at the 90 degrees whilst setting. That way the cable coils correctly out of harms way when the stand is up and lets me keep the cable as short as possible.

I was going to stick my oar in but thought better of it - I thought you wouldn’t have put that picture up without having an answer

 

[Hood]

Yes

Can't as it will be in a different position every time I rotate and also the foot will be at a different angle depending on the terrain.
That is the reason I wanted it to be flexible but also want it to be relatively rigid so that it doesn't rattle about when up.

 

[Shiny Steve]

Just finishing a little handrail for a nice old ladies garden steps. This is a case of function over form but I’ve tried to make it look pleasant.

 

[harveyp6]

Lovely batch of Lista tool cabinets you have there.

 

[atomant48]

Needed a spacer.
But didn’t have the right tools for it.

So did it in my way ;-).

Working really flawless.

That looks really satisfying. What was the spacer for ?

 

[Gragson]

Made a doodaa for the end of a PCP air pistol to protect the silencer adapter thread.
Already had some brass bar and telly was killing me so an hour of relief fiddling.

25mm OD, bored 11.5mm, bit of knurling cos I like it parted 12mm, tapped 1/2" 20 UNF, fits a treat.




Can't beat brass for cheap bling

 

[Shiny Steve]

Lovely batch of Lista tool cabinets you have there.

All saved from the skip

 

[Shiny Steve]

Trialed yesterday made last week. A thingamajig for the little tractor for lifting bulk bags, this minimises me having to get on and off and on and off and on and off again and again and again looping the ears on pallet forks.

It has the most annoying quick hitch, that is nearly a standard but not quite. So all brackets have to be custom made

 

[Erie Fred]

Made a doodaa for the end of a PCP air pistol to protect the silencer adapter thread.
Already had some brass bar and telly was killing me so an hour of relief fiddling.

25mm OD, bored 11.5mm, bit of knurling cos I like it parted 12mm, tapped 1/2" 20 UNF, fits a treat.

View attachment 522719View attachment 522721
View attachment 522722View attachment 522723View attachment 522724

Can't beat brass for cheap bling

I make them 1/2-28, interesting yours is 1/2-20
These are brass, however look like steel.

 

[Erie Fred]

IRD-25 2" receiver hitch addition, I made the red parts.

 

[dieselsamurai]

Finished my sons book case/side table basically just some time and effort free 20mm polycarbonate offcuts and a 4ft bit of scaffold board from the builders working next door



Hopefully something he'll keep and perhaps look at and think of me, i know theres lots of stuff in my workshop and house that remind me of people that meant a lot to me no longer around

 

[Dapph2]

Made a doodaa for the end of a PCP air pistol to protect the silencer adapter thread.
Already had some brass bar and telly was killing me so an hour of relief fiddling.

25mm OD, bored 11.5mm, bit of knurling cos I like it parted 12mm, tapped 1/2" 20 UNF, fits a treat.

View attachment 522719View attachment 522721
View attachment 522722View attachment 522723View attachment 522724

Can't beat brass for cheap bling

Gold is better.