roofman
Purveyor of fine English buckets and mops
- Messages
- 12,425
- Location
- North West with water on 3 sides
- Thread starter roofman
- Start date
Tiggy_dorset
It looks just like a bought one!
- Messages
- 1,970
- Location
- Weymouth, Dorset, UK
A wind up surely 
mike 109444
Member
- Messages
- 4,767
Now yo know where the old tools from Remploy went 
doubleboost
Member
- Messages
- 3,856
- Location
- Newcastle upon Tyne England
At least is says "used"
Mine have been used for 40 years but they don't look like that lol
Mine have been used for 40 years but they don't look like that lol
AndyStobbs
Member
- Messages
- 2,475
- Location
- North West England
Better than the pair you haven't got. Religious as they are a shaft could be verified with them.
Who's gonna ask him if you get the number of a good scrappy with the purchase?
Stunning! Not in my 30 years of Engineering have i ever drilled through a job into a vice, v block or bed of machine etc. Not once!
That's not a wind up i think, he does / has listed fair bit of stuff over time. Not sold a lot obviously by the looks of it......... wonder why!
Kind regards,
Scott
Stunning! Not in my 30 years of Engineering have i ever drilled through a job into a vice, v block or bed of machine etc. Not once!
That's not a wind up i think, he does / has listed fair bit of stuff over time. Not sold a lot obviously by the looks of it......... wonder why!
Kind regards,
Scott
brightspark
Member
- Messages
- 41,034
- Location
- yarm stockton on tees
well if they did come from remploy workshop that would answer your question its anyones guess
pedrobedro
Man at Matalan
- Messages
- 13,066
- Location
- CX near Chesterfield
wheresmejumper
Banned
- Messages
- 2,626
Lightly used in a smoke and pet free environment
skotl
Forum Supporter
- Messages
- 10,115
- Location
- Edinburgh, UK
Errr.... what? Even if they hadn't been nibbled by steel-toothed mice, surely these can't be worth £240 and £300????
Correct the are not worth that money, they are in fact way out value wise. You can get similar size to those for about half the money new last time I was looking about. And if take a good look at those other he has listed they are a bit ropey wear wise.
He has a load of angle plates which are not bad money really (if the condition in the flesh is acceptable) Then he lists some adjustable angle plates that are totally stupid money, you can buy a new equivalent with T slots for a fraction of that money. This is why i said that listing was no joke and i watch what he lists and has up for sale regularly and have seen similar scrap for sale by that seller and similar overpriced items.
Kind regards,
Scott
Flathead_Dave
Member
- Messages
- 325
ide hate to see the ex owners drilling vice
Be my guest
http://www.ebay.co.uk/itm/Machine-vice-/221726995009?pt=LH_DefaultDomain_3&hash=item339ff57241
