I will try this tomorrow or whenever I’m next at the workshop.That is the IP I thought it would be as most of the controllers I have used that connect to Mach go for that.
Aye, manual doesn't really inspire confidence if I am honest.
The likes of the Xtreme one mentioned earlier comes with PC included so all the software etc should be ready set up just for you to plug in.
Then again where is the fun in that
this is in the manual i found could also be wrong
.View attachment 212746
We considered Xtreme but didn’t want another Rtech plasma.Yeah my xtreme table came with everything setup, plugged it in and was cutting 5 minutes later.
I’ll run an Ethernet lead from the house to the workshop if I bloody have to.BTW did you see there was a remote support option? Might not be much use unless you can get connected, maybe a hotspot set up on your mobile would be enough.
I’ll run an Ethernet lead from the house to the workshop if I bloody have to.
I’m talking an Ethernet lead to run another WiFi down to the workshop then I can get support to take over the computeris it a homemade lead or bought?
if homemade does it have good continuance end to end?
I’m talking an Ethernet lead to run another WiFi down to the workshop then I can get support to take over the computer
It shouldn't do, Mach4 certainly doesn't or at least when I was testing it it didn't.Will the software need an internet connection to call home to validate and confirm the licence terms regularly anyway, so much software like to connect regularly to allow continued use these days, our vinyl cutter goes into demo mode if you do not connect to the internet on a regular basis.
Will the software need an internet connection to call home to validate and confirm the licence terms regularly anyway, so much software like to connect regularly to allow continued use these days, our vinyl cutter goes into demo mode if you do not connect to the internet on a regular basis.
Xtreme offer options on the cutterWe considered Xtreme but didn’t want another Rtech plasma.
Xtreme offer Thermacut or Hypertherm. Take your choice.We considered Xtreme but didn’t want another Rtech plasma
I was under the impression they have a range of options....We considered Xtreme but didn’t want another Rtech plasma.