Little Jerry
Member
- Messages
- 140
- Location
- Australia
Hi
just wondering what the best practice / best tools would be to take down a weld on automotive sheet metal to get a seemless finish.
I have been using a 5 inch angle grinder with a 120g flap disc but I don’t feel 100% consistent and am paranoid about taking it down to far or unevenly. 5 inch is potentially too wide and taking metal off the surrounding areas unnecessarily?
Are those 2-3” roloc discs a better option?
Appreciate any guidance
adam
just wondering what the best practice / best tools would be to take down a weld on automotive sheet metal to get a seemless finish.
I have been using a 5 inch angle grinder with a 120g flap disc but I don’t feel 100% consistent and am paranoid about taking it down to far or unevenly. 5 inch is potentially too wide and taking metal off the surrounding areas unnecessarily?
Are those 2-3” roloc discs a better option?
Appreciate any guidance
adam