Ok yes you have a contaminantion issue going on. As we know everything from your machine down to the torch works fine from using them here I would check your gas line connector in the welder and every other joint back up to the bottle for leaks.Busy all week and only today managed to get the Tig fired up for a practise.
Wonderful how quick i have managed to revert back to my first attempt
Only things changed since last Sunday are Filler & Gas.
It’s knackered.Anyone have any suggestions before R-Tech get a call ?
It’s knackered.
I wouldn’t bother calling rtech those regs are thrown in for free with every welder they sell. I’d remove your flow meter and sling it in the bin. Buy a Harris or a gasarc, victor, Esab, boc etc and get something of decent quality.
I would mate. Should be about £40 for something worth having. Those rtech ones are about £1.99 worth at best. Your flow meter would of cost more money.Ok Richard, Will get me a decent example.
Those are multi stage regs. Yeah if your pockets are deep enough I’d always go multi stage due to the initial start up surges been non existent and saving you gas. If it’s a little on the pricey side for you then the equivalent quality in a single stage will also do you fine. Hi lo regs are not bad things.Something like this one maybe ?
Like the longer Bottle connection to get the reg past the handle.
Wonder how long before they have some stock.
https://www.weldequip.com/fabmaster-multi-stage-regulators.htm?cat2=24
Have a look at the esab edge single stage or multi stage there both greatSomething like this one maybe ?
Like the longer Bottle connection to get the reg past the handle.
Wonder how long before they have some stock.
https://www.weldequip.com/fabmaster-multi-stage-regulators.htm?cat2=24
What you gone forSorted now thanks Guys
Big Thank you to the chap i spoke to at Weldequip today, Excellent customer service
You’ll benefit from that.Nice little 2 stage
Nice little 2 stage
If In doubt Dave sling it mate. If it’s old or looking a bit past it don’t take any chances loading it up with the full force of your cylinder content.Nice one?
Not too expensive?
(Ni)
If so, from where? Haven't checked the BOC one I dug up works yet...
Dave H. (the other one)