cutting tidy holes lidl plasma cutter

[Turbo]

Is it possible put a magdrill cutter on standard pillar drill

Yep, drill adapters are available. But you will need a very low geared pillar drill to use one.

 

[Memmeddu]

Holesaw would be my choice. Drill a suitable pilot hole first, seperatly, and fit a peice of HSS lathe tool on the holesaw arbour where the pilot drill would go. It will give a better quality, rounder hole as it wont wobble so much.

Or you could rough cut a 28mm hole, deburr and round with a carbide burr and then finish with a step drill.

.

 

[Keithmac]

When I was cutting my geabox brackets I removed the brunt of the material with the plasma cutter then finished with angle grinder and die grinder.

I would either use a hole saw or plasma plus die grinder for finishing.

Depends how neat you want the hole.

 

[6ply]

and then finish with a step drill.

32mm step drill?

It would also require drilling from both sides, if the material is 8mm thick.

 

[Kram]

32mm step drill?

It would also require drilling from both sides, if the material is 8mm thick.

Nope it is quite conviently the largest size on my step drills (from Lidl I think they were) so you can do it in one.

 

[6ply]

Nope it is quite conviently the largest size on my step drills (from Lidl I think they were) so you can do it in one.

You're right. Should have checked mine first... 32mm.