Sammy7
Member
- Messages
- 385
- Location
- Sheffield UK
I thought I would share the tool I made for the mountain bike.
Basically it a bar of aluminium machined to accept hex bits held in place with neodymium magnets.
Then anodised at home.
The central shaft is a bit of titanium, the hex holder is a modified part (added hinge pin and turned it down) It then locates in the hollow crankshaft. It's never fell out yet even over rough terrain.
Basically it a bar of aluminium machined to accept hex bits held in place with neodymium magnets.
Then anodised at home.
The central shaft is a bit of titanium, the hex holder is a modified part (added hinge pin and turned it down) It then locates in the hollow crankshaft. It's never fell out yet even over rough terrain.