Evening all.
New to the forum.
Need some help with my set up.
For some background, I have done a level 1 welding course and have started level 2.
I am doing this to weld up an old car.
So, I am trying to weld two pieces of 1mm steel.
I have ground each edge clean.
I have ground clean a site for the earth.
I am using the settings in the attached photo, with gas.
Obviously I am doing something amiss, but just can't see what's up.
I am trying to follow the puddle as I have with the equipment at college. Obviously much bigger sets than my home one.
Once cooled, I can just pull the two pieces apart.
Any suggestions would be gratefully received.
Thanks
Ian
New to the forum.
Need some help with my set up.
For some background, I have done a level 1 welding course and have started level 2.
I am doing this to weld up an old car.
So, I am trying to weld two pieces of 1mm steel.
I have ground each edge clean.
I have ground clean a site for the earth.
I am using the settings in the attached photo, with gas.
Obviously I am doing something amiss, but just can't see what's up.
I am trying to follow the puddle as I have with the equipment at college. Obviously much bigger sets than my home one.
Once cooled, I can just pull the two pieces apart.
Any suggestions would be gratefully received.
Thanks
Ian