Good day to you all, first post here.
I am wondering why some migs will always leave the beginning
of the run of weld cold, not burned in like the rest of the run,
and yet others cope much better with this.
Is there any updated can be done to a mig to get better starts.
What makes for a better start, motor ramp to slow down the wire
while the inrush of current to the transformer levels off.
Would a means to increase the voltage at the beginning of the run
and then drop it back to the initial preset value help.
Just curious as to why some welders are better than others,
and if there is any cheap mods that can help.
I am wondering why some migs will always leave the beginning
of the run of weld cold, not burned in like the rest of the run,
and yet others cope much better with this.
Is there any updated can be done to a mig to get better starts.
What makes for a better start, motor ramp to slow down the wire
while the inrush of current to the transformer levels off.
Would a means to increase the voltage at the beginning of the run
and then drop it back to the initial preset value help.
Just curious as to why some welders are better than others,
and if there is any cheap mods that can help.