Topcat2vin
New Member
- Messages
- 24
- Location
- N. Ireland
Hi, I have a project coming up involving welding 1.5m x 1.5m x 2.5mm thk. stainless sheets (304). Butt welding end on end - 1.5m long weld. I am a little worried about the metal warping and think I should weld in 3-4" hit and miss then infill. Is this best approach or is it OK to well straight along (i.e. would the 2.5mm plate warp or is it thick enough to be OK).
IF anyone with experience of this can give some pointers it would be appreciated.
Thanks
IF anyone with experience of this can give some pointers it would be appreciated.
Thanks