Hi there, looking for some advice. Purchased my mig welder some months ago during lock down (pacini pro mig 295). Being able to find little to no info on these welders and now it appears I have a problem. The welder is a 230v unit. For the first couple of months this welder was perfect and on the button. A couple weeks back I flicked the switch on and it hesitated to run, and when it did run the amperage/ volts/wfs would fluctuate -+ 2-3 digits for a while. The coming days this got slightly worse but really not unusable. Just give it a minute or 2 for the fan to kick in and the led screen to fire up. Seeing this ever so slightly deteriorate and have good days and bad days I sent it back to the seller as it was under three year warranty. The seller called me a few days later assuring me there was no problem and it could be my power source even though it worked perfect on the same source the months before. They even showed me a video of them using it etc. Then it was sent back to me. The issue was never really resolved so some days I would come in switch it on and wait 2 mins for the fan to kick in and it to run other days it would be 20 seconds etc. The welding with it itself was never an issue. This evening I switched it on and it refuses to run. It’s like it wants to and is trying to but just hasn’t got it in it. The fan turns but not nearly the full rpm and the lcd is stuck on 00.0 and is faint. I’ve brought the welder to a friends to make sure it wasn’t my power source and it makes no difference. Could someone please tell me if they would have any clue as to what’s going on with it because I’m starting to pull my hair out as I just want to weld with it. I’ll send it back again if needs be but I have a feeling I’ll just be told it’s fine etc. And waste another fortnight with no welder. I really would appreciate any input or advice and sort for my long winded post. Thanks