Bowers2591
New Member
- Messages
- 5
- Location
- London
Hello everyone, my names Adam, im new to the forum but this will probably be my first of many posts after discovering this fountain of knowledge
My enquiry is, I have been practicing vertical up on Mig as I would like to be able to weld out of position if required. After alot of fiddling I think I have whittled down to the right settings but would like to know what is the maximum size of the root pass. I am able to get a very flat pass if I make the width about 10 - 12 mm ( On 10mm material +). Would that be accepted if there is solid fusion all round? I will try to attach a picture if it allows.
thanks in advance guys and look forward to hearing from ya.
My enquiry is, I have been practicing vertical up on Mig as I would like to be able to weld out of position if required. After alot of fiddling I think I have whittled down to the right settings but would like to know what is the maximum size of the root pass. I am able to get a very flat pass if I make the width about 10 - 12 mm ( On 10mm material +). Would that be accepted if there is solid fusion all round? I will try to attach a picture if it allows.
thanks in advance guys and look forward to hearing from ya.