party smith
New Member
- Messages
- 10
- Location
- pisa
hello everyone, some years ago i've bought at 100€ a mig welding machine, tigmig tm150mig, the machine runs in ac but it have a gas connection, i'd like to do some car bodywork with it and i wanted to connect a rectifier and two diodes, but the minimum amerage is 50A and if i try to weld some 0.8 sheet i will probabilly blow holes everywhere. esterday searching on internet i found on aliexpress this welder https://it.aliexpress.com/item/3302...chweb0_0,searchweb201602_2,searchweb201603_53
it says output voltage 20 - 200A (and 7.43€!!), i'm thinking about mounting the chinese welding machine inside the tigmig case keeping the wire engine and the wire speed controller to go down in dc to 20A, would it be possible? i know that tey are two diferent kind of trasformator cc and cv, but is there somekind of conversion i can do?
it says output voltage 20 - 200A (and 7.43€!!), i'm thinking about mounting the chinese welding machine inside the tigmig case keeping the wire engine and the wire speed controller to go down in dc to 20A, would it be possible? i know that tey are two diferent kind of trasformator cc and cv, but is there somekind of conversion i can do?