31mm gap between two 140x250mm plates.
that was absolutely ridiculous job.
i've used 2 units one was a 500A with MB501 torch:
and a 300A unit without water cooled torch which was much smaller. and i had good results with a correct angle.
but not in there...
how would You weld it? im thinking MMA would work, but i didnt had a go with it.
that was absolutely ridiculous job.
i've used 2 units one was a 500A with MB501 torch:
and a 300A unit without water cooled torch which was much smaller. and i had good results with a correct angle.
but not in there...
how would You weld it? im thinking MMA would work, but i didnt had a go with it.