- Thread starter God mode restorations
- Start date
Dell
Member
- Messages
- 240
- Location
- Warwickshire
I received something I had been after for ages a small powered hacksaw.
It’s a Kennedy Hexacut 60 originally supplied without motor so no cast base, the motor is a bit weak but starts once helped , no on/off or cutout switch but apart from that it just needs a clean, not sure if I am going to get the current motor serviced or change it or even convert it to 24volt.
I will use it as is for now apart from adding a switch as picture until I decide.
It’s a Kennedy Hexacut 60 originally supplied without motor so no cast base, the motor is a bit weak but starts once helped , no on/off or cutout switch but apart from that it just needs a clean, not sure if I am going to get the current motor serviced or change it or even convert it to 24volt.
I will use it as is for now apart from adding a switch as picture until I decide.
