So I finally finished getting my old SIP 180A up and running!
I've fitted new liner, motor brushes and regreased the feed motor gearbox.
My first project is some patches on my MK2 Ford Galaxy.
I tried laying down some welds on some scrap, but only to check it works, nothing descent.
I'm going to using 0.8mm sheet, 0.6 wire and argoshield lite.
Can anybody advise a good base settings for 0.8mm sheet for this welder?
Unfortunately it hasn't got a settings table inside the lid.
I've fitted new liner, motor brushes and regreased the feed motor gearbox.
My first project is some patches on my MK2 Ford Galaxy.
I tried laying down some welds on some scrap, but only to check it works, nothing descent.
I'm going to using 0.8mm sheet, 0.6 wire and argoshield lite.
Can anybody advise a good base settings for 0.8mm sheet for this welder?
Unfortunately it hasn't got a settings table inside the lid.