Resin printer question

[MattF]

Room temperature is fairly consistent, as the wood stove's been going whenever I'm home. Humidity is relatively consistent too, as there's a dehumidifier in here, keeping it to around 60/65%.

 

[daedalusminos]

It looks as if you're printing solid?

Resin printing is a fight between film adhesion and interlayer strength/support strength/build plate adhesion.

Stirring the resin thoroughly in the vat to expose the film to air can help reduce film adhesion.

Making the model hollow will reduce film adhesion since surface area will be reduced.

It looks like some supports failed before the layer delaminated.

What does the model look like?

 

[MattF]

That particular failure is this one. It's printed fine once. Yes, I'm printing it solid.

Post in thread 'Stuff your 3D printer has made today...'

Feb 23, 2026

A fairy house. Currently in the curing unit.




It took me ages to remove all the supports from that one, & the inside of the printer looked like a bairn had been having a bath in there, after printing it.

• MattF

• 

Had same failure above on a different model, hence why I tested with this one, again.

This is the current state of the film. It's done approx. 10,000 layers so far.

 

[daedalusminos]

Are the roots fully supported? You can get an issue where a fault will spread

 

[MattF]

Not sure. I'll check on that.

 

[MattF]

Well, base facing towards the plate, it was having none of it, so I've now got it printing on its side. We shall see how this one goes. The noises I'm hearing from the machine currently are making me feel optimistic of its chances.

 

[MattF]

Finally.



It's taken several failed attempts, but taught me a valuable lesson regarding resin printers. As much of the print area as possible facing/touching the buildplate, so that the print doesn't rip itself apart.

 

[MattF]

Got another print in there now, curing.



Another question or two. A quick search online suggests acrylic paints are good for resin prints? Are they child friendly, as in a 4 year old would be okay using them?

 

[My Old Landy]

Got another print in there now, curing.

View attachment 531840

Another question or two. A quick search online suggests acrylic paints are good for resin prints? Are they child friendly, as in a 4 year old would be okay using them?

I use acrylic paint on my resin models. I use a primer first. I wouldn't trust a youngster with them as I don't think they are safe. They carry a warning on their contents.

 

[MattF]

Cheers. I'll skip acrylics then.