brewdexta
The biggest tool in the box
- Messages
- 5,492
- Location
- UK
I've got a couple to make in steel, one goes from 100 round OD to a 75 x 98 OD rectangle to fit on the back of the Wadkin bandsaw. The rectangle will push inside the bandsaw nicely then I can hook it up to my ducting with a short length of flexible hose.
The other goes from 100mm round OD to 77 x 39 rectangle, this is to fit on the Bill Pentz cyclone I'm making. This will slide over the inlet which is 75 x 37.5 and then marry up to the 100mm spiral duct from the barn to the workshop above.
Has anybody got the software to make patterns for these so I can bend them myself? I could have sworn somebody posted a link to a free phone or PC app a while ago?
Cheers
Andy
The other goes from 100mm round OD to 77 x 39 rectangle, this is to fit on the Bill Pentz cyclone I'm making. This will slide over the inlet which is 75 x 37.5 and then marry up to the 100mm spiral duct from the barn to the workshop above.
Has anybody got the software to make patterns for these so I can bend them myself? I could have sworn somebody posted a link to a free phone or PC app a while ago?
Cheers
Andy