Furry Freak
Member
- Messages
- 300
I still haven't actually worked out why I'm doing this, but it's keeping me out of the cocktail cabinet for a bit. Making a replacement steel bumper for my Land Cruiser. Still learning this welding lark and I need a bigger circuit breaker so I can up the power to max, but it's not going to fall apart.
Quite a bit more to do. Got a bit of distortion in the side panel which I beat out OK. Going to put jacking points in and other bits and pieces. Need some mounts at the ends to stop it getting ripped off in a trench too. Lights need to go in and finally the compressor outlet connection. I'm sure there are easier techniques, but I am learning the whole fabrication thing as I go along.
FF
Quite a bit more to do. Got a bit of distortion in the side panel which I beat out OK. Going to put jacking points in and other bits and pieces. Need some mounts at the ends to stop it getting ripped off in a trench too. Lights need to go in and finally the compressor outlet connection. I'm sure there are easier techniques, but I am learning the whole fabrication thing as I go along.
FF