Re-finishing a bad paint job - is 29107 the magic bullet?

[charlysays]

One of the reasons I used epoxy on my project is because it was sat outside and normal primer and fillers suck in moisture.

I think you need to get all the filler-primer removed as it will come back to bite you later.

I took a lot of filler out of my panels (far to much, they must have got carried away).

Don't think they do Nisocoat2 in Atlas Grey which is a real shame, heard nothing but good reports about it.

Check if hmg have the formulation. Nisocoat 2 clear coat over a normal automotive solvent base is another option.

 

[charlysays]

They will mix custom colours.

I took a piece of car into M & P in Chester, looking for the nearest standard colour match, but I don't think they do colour chips for it, so they ended up scanning the part and ordering in a custom mix from HMG. Took about a week to come back. Cost of the paint was the same.

(Yes, I'll get rid of all the filler )

This is good to know!
The place near me which mixes nisocoat 2 said "no colour matching or custom formulations, we won't even guarantee a match from a paint chip as it's an industrial coating". Lol. Living out in the sticks sucks sometimes.