Hi guys, I've recently started using 4T on my jasic 350 mig settings at 11 on wfs and 24v welding some brick angles out of 10mm plate (10 mm fillet welds)
After 10 minutes or so of weld these beasts I find my self having to change tips all the time and I think it' snagging further back in the lance because I can feel it!!!
Inductance set to 5 (dial 1-10)
Tried the current crater control (dial with 1-10)
And current voltage control (dial with 1-10)
But to be honest I've never had to use them because I always weld on 2T and these dials only apply to 4T
Also changed the liner and the set is only 2 years old
Hope this makes sense and any help would be very much appreciated
After 10 minutes or so of weld these beasts I find my self having to change tips all the time and I think it' snagging further back in the lance because I can feel it!!!
Inductance set to 5 (dial 1-10)
Tried the current crater control (dial with 1-10)
And current voltage control (dial with 1-10)
But to be honest I've never had to use them because I always weld on 2T and these dials only apply to 4T
Also changed the liner and the set is only 2 years old
Hope this makes sense and any help would be very much appreciated