So what exactly has happened there?Here is a very mild one of a missing G50.
I don't like watching them but as said this one is mild so not too bad.
Below is a video of a friends lathe showing that, you can hear/see the spindle speed increase/decrease depending on the diameter.
PerfectionNice part, lovely finish
Below is a video of a friends lathe showing that, you can hear/see the spindle speed increase/decrease depending on the diameter.
LOLthats a fine looking lathe controller
Chipmaster is rigid enough. You can power-part on a Myford ML7 if it is set up right and you use the correct tooling.