vw1
Member
- Messages
- 1,050
- Location
- solihull uk
Hi all
More advice needed please. This time round I'm working on the bonnet. I have used a da and took it back to original primer and in some areas gone through to the metal where stone chips has rusted through.
So my question is shall I epoxy the bare metal area then use a barrier coat over the hole panel ? Then base and lacquer ?
On the wings I done earlier I took it back to bare metal so I epoxy the hole wing so was straight forward in prep etc.
Also I used epoxy 421from rustbusters but have now ran out . So advice on an alternative epoxy primer please .
Learning as I go so be kind.
Best regards.
More advice needed please. This time round I'm working on the bonnet. I have used a da and took it back to original primer and in some areas gone through to the metal where stone chips has rusted through.
So my question is shall I epoxy the bare metal area then use a barrier coat over the hole panel ? Then base and lacquer ?
On the wings I done earlier I took it back to bare metal so I epoxy the hole wing so was straight forward in prep etc.
Also I used epoxy 421from rustbusters but have now ran out . So advice on an alternative epoxy primer please .
Learning as I go so be kind.
Best regards.