Brad93
Member
- Messages
- 17,573
- Location
- Essex, United Kingdom
I've got a leaking water cooled torch, it's got a swivel neck and the o rings are not sealing.
I've measured the two grooves in the torch. The first is ID 11.70mm And OD 14.80mm.
The second is 13.70mm ID and OD 16.50mm.
Width of both grooves is 1.4mm.
Measuring the Old o ring cross section with vernier calipers seems to suggest its 1.4-1.5mm
any advice on what size I need?
I've measured the two grooves in the torch. The first is ID 11.70mm And OD 14.80mm.
The second is 13.70mm ID and OD 16.50mm.
Width of both grooves is 1.4mm.
Measuring the Old o ring cross section with vernier calipers seems to suggest its 1.4-1.5mm
any advice on what size I need?