oddball90
Member
- Messages
- 522
- Location
- Northampton. UK
Hi Everybody,
New to this site just ordered a ac/dc tig welder from weldquip so might be in need of some help, done a fair bit of mig welding using a 400amp 3 phase mig welder, sealey supermig 150, sealey supermig 180 and now got a boc 180(cerbora). Welded skips to citreon saxo floor pan, the roll cage that i built on my land rover was tested well when i barrel rolled it down a 120ft hill bouncing of it's roof and doing 1 full revolution in the air. Not a fault found with the cage when it was reinspected, had to make and weld 3 more cages for friend's land rovers. Has anybody used a portamig 206i tig welder? Bought it on the reports on the mig welders that weldquip sell.
Here is a photo of my first trialer that i built from scratch.
Oddball
New to this site just ordered a ac/dc tig welder from weldquip so might be in need of some help, done a fair bit of mig welding using a 400amp 3 phase mig welder, sealey supermig 150, sealey supermig 180 and now got a boc 180(cerbora). Welded skips to citreon saxo floor pan, the roll cage that i built on my land rover was tested well when i barrel rolled it down a 120ft hill bouncing of it's roof and doing 1 full revolution in the air. Not a fault found with the cage when it was reinspected, had to make and weld 3 more cages for friend's land rovers. Has anybody used a portamig 206i tig welder? Bought it on the reports on the mig welders that weldquip sell.
Here is a photo of my first trialer that i built from scratch.
Oddball