tom-madbiker
Member
- Messages
- 322
- Location
- Chesham, UK
OK my old murex has developed a fault the feed is erratic it slows down and speeds up whilst welding so one minute it's burning back and the next blobing on the job I thought the feed motor was bad so I have replaced that with another also the pot for the feed as it looked worn but it's still doing it any ideas it's fairly basic inside copper wound transformers ect and just the one board as far as I can see a few years ago I replaced the two transistors on the board as it started feeding continuously even without the trigger being pressed
Thanks in advance Tom
Thanks in advance Tom