cracker666
Don't follow me I'm lost too.
- Messages
- 221
Well made a couple of those there copper chill bars. I like reusing otherwise scrap material.
I'm going to make quite a few of these 15mm and 22mm bents and straights.
Found a old bit of sheet in the loft I cut from a template, with no shaping.
We have rain planned for this afternoon and the wife wants to go out :-(.
Will I have enough time to do the headlight repair, hope so then I'll be on track for the heater and sill repair.
I keep looking at mig welders on eBay, but mine is ok and I don't know if it's me or the machine.
I'm going to make quite a few of these 15mm and 22mm bents and straights.
Found a old bit of sheet in the loft I cut from a template, with no shaping.
We have rain planned for this afternoon and the wife wants to go out :-(.
Will I have enough time to do the headlight repair, hope so then I'll be on track for the heater and sill repair.
I keep looking at mig welders on eBay, but mine is ok and I don't know if it's me or the machine.