Hi all
its been a while since I posted on here but was hoping someone could help me?
Ive got an ERP150.
Its an old machine that I bought second hand a couple of years ago. I fitted a new euro torch to it straight away with a gas solenoid. Probably shouldn't have wasted my money on it really and should've just bought a better or new mig in the first place but I really only had a couple hundred quid to spend on it.
I was using it the other day to mig the exhaust on my Previa. Use it a while then the wire breaks and I have to pull it out of the steel liner. It looks like it its, cut or burnt. I wonder if maybe the wire liner is shorting out an causing the wire to break. Or if its maybe something to do with where it goes through the wire feed mechanism.
The wire feed mechanism seems to be a bit rubbish is there a better one I could replace it with? Think this would help it or not?
Thanks in advance for any replies.
Bobo
its been a while since I posted on here but was hoping someone could help me?
Ive got an ERP150.
Its an old machine that I bought second hand a couple of years ago. I fitted a new euro torch to it straight away with a gas solenoid. Probably shouldn't have wasted my money on it really and should've just bought a better or new mig in the first place but I really only had a couple hundred quid to spend on it.
I was using it the other day to mig the exhaust on my Previa. Use it a while then the wire breaks and I have to pull it out of the steel liner. It looks like it its, cut or burnt. I wonder if maybe the wire liner is shorting out an causing the wire to break. Or if its maybe something to do with where it goes through the wire feed mechanism.
The wire feed mechanism seems to be a bit rubbish is there a better one I could replace it with? Think this would help it or not?
Thanks in advance for any replies.
Bobo