cardiffrob
Member
- Messages
- 1,623
- Location
- Wales, Llantwit Major.
I ballsed up.
I converted a 1930s Morris to take an MG axle but the U-bolts are too short and the old MG ones are the wrong diameter.
Has anyone made their own and if so, how safe are they???
I need them to fit round a 2 inch diameter, have 6 inches from the inner face at the top of the loop to the bottom of the thread and be 5/16 (8mm in funny money) diameter.
Any suggestions as to how to make or buy some?
Located in Wales.
Ta!
I converted a 1930s Morris to take an MG axle but the U-bolts are too short and the old MG ones are the wrong diameter.
Has anyone made their own and if so, how safe are they???

I need them to fit round a 2 inch diameter, have 6 inches from the inner face at the top of the loop to the bottom of the thread and be 5/16 (8mm in funny money) diameter.
Any suggestions as to how to make or buy some?
Located in Wales.
Ta!