sprayerDrew
Perfession not a hobby !
- Messages
- 278
- Location
- uk
hi guys i have a proffesional abac 3hp 200l compressor at 15cfm. It will eventually be going in a garage. This easily will power most air tools but the only issue i have is a da sander! A well known 3m or mirka one uses 17cfm i know my compressor will run this but i dont know how well yet!
I have also got a small sip with a 50l tank which should easily produce 4cfm if not more. i think if i connected both compressors with a y pice then it will easily produce enough air and more atleast around 20cfm.
Would i be correct ?
If so would they both run sufficiently as they wil be taking stress off each other ?
Ideally 2 air lines running at once would be good too
any help would do guys
Thanks Drew
I have also got a small sip with a 50l tank which should easily produce 4cfm if not more. i think if i connected both compressors with a y pice then it will easily produce enough air and more atleast around 20cfm.
Would i be correct ?
If so would they both run sufficiently as they wil be taking stress off each other ?
Ideally 2 air lines running at once would be good too
any help would do guys
Thanks Drew