Kempi Minarc Evo 180

[Tighobby]

Munkul, wrong thread

 

[Tighobby]

I use Teflon for everything (just too lazy).

Does it last?

 

[Pigeon_Droppings2]

Does it last?

Seems ok to me...but i only do hobby use. I did destroy a teflon liner by feeding the wire thro when it wasn't straight...that was very annoying as it came straight through the hose!

With the replacement motors you need to get the right code to get the correct shaft size.

 

[Tighobby]

it was supposed to be right code from a member here who has the same welder.

 

[Pigeon_Droppings2]

it was supposed to be right code from a member here who has the same welder

On mine I was able to just clean out the internals and then put it back together...plan was to replace if it breaks again but so far it's been working fine.

 

[Munkul]

Munkul, wrong thread

not really, I was replying to the original thread whereas you've hijacked it

 

[Tighobby]

I did this experiment, I used a little luggage scales and measured the pull needed for 1. straight torch cable, 2. a normal kinked as when used and 3. when is all wound up.
1. about 0.2 - 0.35kg
2. 0.8 - 1.6kg
3. 3kg +
Can others check theirs so we can compare? Thanks

 

[Tighobby]

... also would knurled wheel damage normal gas wires if used. Knurled should be used with gasless only they said.

 

[Tighobby]

I replaced the motor and have this issue - speed is not stable, it’s jerking especially at higher speeds. Anybody seen similar problem.