Bob Rivers
Member
- Messages
- 54
- Location
- berkshire
So I have a lovely '18 Vulcan s with 17000 miles on it. Last week I replaced the chain and sprockets and everything was fine.
Except it wasn't, I used the master link/clip and it failed, I'm sure I did everything correctly but I clearly didn't and it broke - I was VERY lucky as I was going fairly slow and hadn't joined the M4 where I was heading and all it took out was an oil feed pipe and half of the hole in the case it was mounted to.
Now this hole has about 8mm untapped at the bottom and I want to get an m5x1.0 bottom tap - I'd love any recommendations as to where to get one - I'm cold, tired and Google is not my friend today...
Except it wasn't, I used the master link/clip and it failed, I'm sure I did everything correctly but I clearly didn't and it broke - I was VERY lucky as I was going fairly slow and hadn't joined the M4 where I was heading and all it took out was an oil feed pipe and half of the hole in the case it was mounted to.
Now this hole has about 8mm untapped at the bottom and I want to get an m5x1.0 bottom tap - I'd love any recommendations as to where to get one - I'm cold, tired and Google is not my friend today...