Mike Pinches
Member
- Messages
- 125
- Location
- North Wales
Hi, I had my first go at scratch start tig tonight, only did a few short runs as didn't have much time to get into the garage. If any one can offer any advice that would be great. I had the argon at 7lpm and the welder set at 60 amps. I think this was a bit low as it took a long time for the puddle to form, but at least gave me time to focus on what I was doing.
My first attempt was the very short run top right, and my last run being bottom right. The 2 very bad runs in the middle I had a contaminated tungsten and think I tried travelling too fast.
Thanks,
Mike
My first attempt was the very short run top right, and my last run being bottom right. The 2 very bad runs in the middle I had a contaminated tungsten and think I tried travelling too fast.
Thanks,
Mike