Just looked back on Cutwel is was an SSSCRNeutral rake?
Think you are probably talking about the same thing.
Neutral is usually the insert position such as left, neutral, right.
Inserts are usually positive or negative.
Ah ok, positive insert, too expensive for me, only 4 cutting edgesJust looked back on Cutwel is was an SSSCR
Like mine with only 1.5hp.Ah ok, positive insert, too expensive for me, only 4 cutting edges
Also much weaker but often required for a lower powered lathe.
Thought you had a Colchester student or master or something like that?Like mine with only 1.5hp.
I totally understand everything you just said. Honest.You would just end up with hundreds of worn out 80 degree edges on the CNMG's as you will wear them out at a rate of 100:1 compared to the 100 degree edges for chamfering
You mean I'll end up with tens of them, given enough time?You would just end up with hundreds of worn out 80 degree edges on the CNMG's as you will wear them out at a rate of 100:1 compared to the 100 degree edges for chamfering