chester dylan
Member
- Messages
- 193
- Location
- chester uk
Is there a laymans rule of thumb for rpm and feed rate for end mills slot drills and roughing mills
so far iv been running my mill where it seems right but im shure theres a lot more to it iv done a bit of googling but all i seem to find is complex equations. I undestand that the harder the materal the more flutes you want on your cutter but thats as far as iv got.
so far iv been running my mill where it seems right but im shure theres a lot more to it iv done a bit of googling but all i seem to find is complex equations. I undestand that the harder the materal the more flutes you want on your cutter but thats as far as iv got.