Hi all
Most of my welding will be short runs may 4" or less and stop start to avoid distortion/blow through.
I though it would be easier for me if I cut my rods in half ?
There will be a bit more waste but they will be easier to control ?
I though a simple jig to hold say 6 of them at a time and run the angle grinder over them ?
Then just file off some of the flux ?
regards Paul
Most of my welding will be short runs may 4" or less and stop start to avoid distortion/blow through.
I though it would be easier for me if I cut my rods in half ?
There will be a bit more waste but they will be easier to control ?
I though a simple jig to hold say 6 of them at a time and run the angle grinder over them ?
Then just file off some of the flux ?
regards Paul