LandRoverTom
Member
- Messages
- 154
- Location
- South West GB
Morning all.
I've been browsing here for a while and have just collected an R-Tech MIG180 thanks to the Red Victor auctions last week (stand by for plenty of what am I doing wrong posts when I finally find the time) so thought I'd start simple!
What does everyone use for cutting stock?
I'd like to invest in a chop saw but can't really afford that at the minute so my options currently are ye olde faithly hand-raulic 12" hacksaw or the 4 1/2 inch angle grinder. Both do the job fine for now. But looking for anything more eficiant to get a more accurate cut.
(yes slightly lazy and I know that applying patience, a hack saw or small angle grinder can make a neat job)
My brother has a 98" band saw for his wood working that I'm temped to get a band for to do small pieces.
What would people recomend if I did this? TPI and suppliers?
I've been browsing here for a while and have just collected an R-Tech MIG180 thanks to the Red Victor auctions last week (stand by for plenty of what am I doing wrong posts when I finally find the time) so thought I'd start simple!
What does everyone use for cutting stock?
I'd like to invest in a chop saw but can't really afford that at the minute so my options currently are ye olde faithly hand-raulic 12" hacksaw or the 4 1/2 inch angle grinder. Both do the job fine for now. But looking for anything more eficiant to get a more accurate cut.
(yes slightly lazy and I know that applying patience, a hack saw or small angle grinder can make a neat job)
My brother has a 98" band saw for his wood working that I'm temped to get a band for to do small pieces.
What would people recomend if I did this? TPI and suppliers?