foy9999
Member
- Messages
- 257
- Location
- East Kilbride
I have a large engine-block with some deeply-recessed studs in it which won't budge using any 'conventional' methods (eg 4 foot breaker bar_
I want to put it in an oven to heat it up so the aluminium expands enough to loosen it's grip on the studs
I see an industrial oven for sale near me for not much money
It will probably be for 3-phase supply (listing doesn't say). If it is and I connected it to 240V supply I don't think I'd get as much heat out the elements. They probably have higher resistance.
Short of swapping the elements for 240V ones is there any other way round this?
I want to put it in an oven to heat it up so the aluminium expands enough to loosen it's grip on the studs
I see an industrial oven for sale near me for not much money
It will probably be for 3-phase supply (listing doesn't say). If it is and I connected it to 240V supply I don't think I'd get as much heat out the elements. They probably have higher resistance.
Short of swapping the elements for 240V ones is there any other way round this?