Gareth0123
You'll need 16 pigs to do the job in one sitting!
- Messages
- 1,559
- Location
- Norwich, Norfolk, UK
CAD: How difficult is it for a beginner, and how do I get started?
I was never allowed near a PC/CAD station when I worked for Sanderson/Claas/Caterpillar. I did all of the engineering drawings I required the old fashioned way with pencil & pen, beam compass and trammel, and drawing board and engine.
However it is getting to the point where I need to undertake drawings on CAD so that I can for various reasons email them around the world.
But where do I start?
I was never allowed near a PC/CAD station when I worked for Sanderson/Claas/Caterpillar. I did all of the engineering drawings I required the old fashioned way with pencil & pen, beam compass and trammel, and drawing board and engine.
However it is getting to the point where I need to undertake drawings on CAD so that I can for various reasons email them around the world.
But where do I start?