paulmitchell1984
Member
- Messages
- 814
- Location
- Leeds
Looking to do some bending of heavier guage material nothing above 10-12mm but I would rather hear it to make it abit easier.
At work we use the induction heater or oxy propane, but just curious what people use in their home shops, as my house insurance wernt massively keen on me keeping oxy acetylene at home for obvious reasons..is there a way to just heat with propane? Or other alternatives. Ideally like to keep the heat fairly concentrated rather than say using a forge which will heat a bigger area.
At work we use the induction heater or oxy propane, but just curious what people use in their home shops, as my house insurance wernt massively keen on me keeping oxy acetylene at home for obvious reasons..is there a way to just heat with propane? Or other alternatives. Ideally like to keep the heat fairly concentrated rather than say using a forge which will heat a bigger area.