Anyone got any spare round bar off cuts ?? Specifically 50-53mm OD if possible.

[Wallace]

This is a great forum.

Well worth the £10 donation.

 

[tedmagnum]

Well worth the £10 donation.

I'll be happy to donate once I'm out of the red



Isn't the forum supported/provided by the Weldequip shop or are they just a sponsor ??

 

[madkayaker]

Not sure of full details but there is support from weldequip. The donations are used to pay for time of pro welders for time taken to film tutorials and the like not for server cost etc

 

[dan.taylor.1]

a kangoo is basically a clio with a big back end! should be a doddle, i seem to think i did one with a hammer once when the press broke..!

 

[tedmagnum]

a kangoo is basically a clio with a big back end! should be a doddle, i seem to think i did one with a hammer once when the press broke..!

My press pressure gauge hit 4 tons before it went in...

I tried with a BIG hammer before buying the press. It didn't budge and something was going to break or the shatter.

But yeah, you're right. They are just big clios.

 

[dan.taylor.1]

I did a quad bike one recently that hit 10 tons before it went in.. and that was only 60ish mm wide! Got a bit worried i was going to break the hub tbh!

Dan

 

[Wallace]

I did a quad bike one recently that hit 10 tons before it went in.. and that was only 60ish mm wide! Got a bit worried i was going to break the hub tbh!

Dan

If you don't have a pressure gauge to look at they go in so much easier!

 

[dan.taylor.1]

Haha so true!