Bouledogue
Member
- Messages
- 166
- Location
- France
Thank you, @Endeleus . I shall watch that.I watched an interesting video last week on Neil Paskin's YouTube channel (Pask Makes) where he used traditional rivetting on a new gate build.
Thank you, @Endeleus . I shall watch that.I watched an interesting video last week on Neil Paskin's YouTube channel (Pask Makes) where he used traditional rivetting on a new gate build.
There's a pub (possibly was) in Redditch with an undershot water wheel in the bar with a 15foot glass floor over the race, surprising how many blokes would walk round it.I think, take the brickwork down, then cover with with a lattice of thin sticks, and cover them with some dead leaves.
House in the village has got a well in the middle of their kitchen floor. Its about 35 metres down to the water, and its covered with a very thick glass plate. Its quite unnerving to walk across![]()
There is a pub & restaurant, Egypt Mill in Nailsworth, Glos that has 2 waterwheels in the bar. When they ran them, the rumble from the old gears & shafting could be felt throughout the building. I’m not sure if they still run them, as last I heard, they couldn’t find anyone able to repair them.There's a pub (possibly was) in Redditch with an undershot water wheel in the bar with a 15foot glass floor over the race, surprising how many blokes would walk round it.
My Aunts well had a shed type pent roof over it with two doors for access
surprising how many blokes would walk round it.
That is also a nice idea. Thank you, @Turbo .Unless you are really set on seeing the water i would suggest making a steel or wooden frame and cover it with 40mm hardwood planks, oak would look really nice.
Maybe you could borrow "Samantha" to make one.That's very smart, @Onoff.
Now, do you think my wife would notice if I were to get one with a big willy in the middle of it...?![]()
Currently, the water is about 10 metres down, because we have had good rain over the winter. In summer, where we often have months without rain, it goes much, much lower. Have never seen the bottom. Have never fished for treasure in it, mainly because I get scared leaning over the side...Just out of interest, how far down is the water ? Have you been fishing with a grappling hook ?
I would restore the roof and winder, as you say.
A cheap grating could be made of a piece or rebar mesh.
Allowed to rust any grating would look very traditional. I like old stuff.
You'd better make sure Skippy or Lassie are watching when you go magnet fishing.because I get scared leaning over the side...
Where about are you ? A friend lived in Nogent le Rotrou and found a couple of rusty weapons down his, probably hidden by the Maquis.Currently, the water is about 10 metres down, because we have had good rain over the winter. In summer, where we often have months without rain, it goes much, much lower. Have never seen the bottom. Have never fished for treasure in it, mainly because I get scared leaning over the side...
I too like old stuff. I am probably going to go with rivetted flat-bar (or a hybrid), because I am keen to use it as a practice-run for various gates I need to repair and/or replace at some point.
Oh wow! That's exciting. A long way from us. We are down in l'Aveyron.Where about are you ? A friend lived in Nogent le Rotrou and found a couple of rusty weapons down his, probably hidden by the Maquis.
It was. This was back in '95. After a bit of research he found they were quite active there, and met a couple of them.Oh wow! That's exciting. A long way from us. We are down in l'Aveyron.
Where about are you ? A friend lived in Nogent le Rotrou and found a couple of rusty weapons down his, probably hidden by the Maquis.







