Sparkey
Bouncing along!
- Messages
- 5,156
- Location
- France
So you're a "tacker" then Gav the welder?
I had a prod welder's worst nightmare last week...
Some idiot from Quality found a weld that was 3 mm (!) too short according to the plan.......next thing i know they were mesuring ALL the beads on the finished parts! Assembly line shut down.....oh and then the sh*t hits the fan......
Waited all day for the results of the destruction test.....stressed out all day because if my welds didn't make the test they would have to notify PSA Peugeot to shut down their assemby line...... just for a few mm of weld!
I almost passed out when the boss came to tell us that i've passed the test.....pfew!!! close one!
I had a prod welder's worst nightmare last week...
Some idiot from Quality found a weld that was 3 mm (!) too short according to the plan.......next thing i know they were mesuring ALL the beads on the finished parts! Assembly line shut down.....oh and then the sh*t hits the fan......
Waited all day for the results of the destruction test.....stressed out all day because if my welds didn't make the test they would have to notify PSA Peugeot to shut down their assemby line...... just for a few mm of weld!
I almost passed out when the boss came to tell us that i've passed the test.....pfew!!! close one!