123hotchef
Member
- Messages
- 13,952
- Location
- Kent
The lathe is working hard today after a good hour of repetaive work lots of stop start on 30-40 of the same thing.
The RCD trips out when I start the lathe between changing work pieces.
Leave it for 10 minutes or so and I can get another 20 minutes work before it happens again.
Question is what would be the cause of the tripping RCD?
Its a bit of a pain becuase the one in the workshop trips a does the one in the house feeding the work shop.
Could it be the capacitor that feeds the motor?
The RCD trips out when I start the lathe between changing work pieces.
Leave it for 10 minutes or so and I can get another 20 minutes work before it happens again.
Question is what would be the cause of the tripping RCD?
Its a bit of a pain becuase the one in the workshop trips a does the one in the house feeding the work shop.
Could it be the capacitor that feeds the motor?