angellonewolf
Member
- Messages
- 8,115
- Location
- bristol england
Ok in sure I've posted a thread on a hedge trimmer a while ago
It's been sat in a corner for a while after a head rush and mix of beer one night I found what seamed to be a good details on the bore size and after beer googles measure of the bore i bought a cheap China copy
Now this may sound daft but it's a try as I've had a generator for a couple of years that I've kept around until my garage was done so if this works I could possibly do the gen at a later date
Now pics of the ring as it's in the bore as can be seen about a couple mm to big
Now this needs to be cut down to the right size how much gap should there be between the 2 ends of the ring and the pistion has a round pin in it how do I make it fit and what sort of torralance do I need to worry about
Can I just remove the pin ? That would make it a lot easyer ? Or I'm assuming it there to stop the ring from spinning around ?
It's been sat in a corner for a while after a head rush and mix of beer one night I found what seamed to be a good details on the bore size and after beer googles measure of the bore i bought a cheap China copy
Now this may sound daft but it's a try as I've had a generator for a couple of years that I've kept around until my garage was done so if this works I could possibly do the gen at a later date
Now pics of the ring as it's in the bore as can be seen about a couple mm to big
Now this needs to be cut down to the right size how much gap should there be between the 2 ends of the ring and the pistion has a round pin in it how do I make it fit and what sort of torralance do I need to worry about
Can I just remove the pin ? That would make it a lot easyer ? Or I'm assuming it there to stop the ring from spinning around ?