RWD3M Forum Supporter Messages 2,846 Location Wiltshire, UK Oct 4, 2018 #21 1/2" Pete. I've ordered up a length of steel stock, should arrive by the weekend.
Pete. Member Messages 14,142 Location Kent, UK Oct 4, 2018 #22 All I would do is put a decent knurl on each end, loctite the end into the clutch arm and glue the other end into a drilled plastic ball (or cut a thread on it and screw the ball on)
All I would do is put a decent knurl on each end, loctite the end into the clutch arm and glue the other end into a drilled plastic ball (or cut a thread on it and screw the ball on)
RWD3M Forum Supporter Messages 2,846 Location Wiltshire, UK Oct 10, 2018 #23 Hi Pete, Material arrived Monday and I've got knobs on order too, so I'll make up the new one this weekend. By the way, I went down to G and M Tools yesterday and I'm glad I didn't take the trailer with me, I could have spent a fortune! Nevertheless, I did get the change gear spindle thingy I was after and also a new gear lever/speed chart for the top of the headstock. Nice day out too, lunch by the seaside and traffic not as bad as it might have been. Regards, Richard.
Hi Pete, Material arrived Monday and I've got knobs on order too, so I'll make up the new one this weekend. By the way, I went down to G and M Tools yesterday and I'm glad I didn't take the trailer with me, I could have spent a fortune! Nevertheless, I did get the change gear spindle thingy I was after and also a new gear lever/speed chart for the top of the headstock. Nice day out too, lunch by the seaside and traffic not as bad as it might have been. Regards, Richard.
slim_boy_fat Forum Supporter Messages 29,501 Location Scottish Highlands Oct 10, 2018 #24 RWD3M said: I could have spent a fortune! Click to expand... Always the way