chevy2
Member
- Messages
- 1,632
- Location
- Herts.
Today i had to convert a 4ft length of 50 x 50 x 3mm box section into a channel section,
Basically cut one complete side off along the full length which would have been two 4ft long slits with the 1mm cutting disc,
my plasma is one of those tools i dont use daily but on this job it was worth its weight in gold by simply clamping a straight edge as a guide i had two near perfect cuts with minimal clean up within a few minutes
Basically cut one complete side off along the full length which would have been two 4ft long slits with the 1mm cutting disc,
my plasma is one of those tools i dont use daily but on this job it was worth its weight in gold by simply clamping a straight edge as a guide i had two near perfect cuts with minimal clean up within a few minutes